Pure Glow Carmen Hole in the Wall Gas Fire
Product No: FS2016
- Maximum heat output of up to 3.8Kw
- Manual control only
- Choice of finish either Traditional All Black Cast Iron or Contemporary Full Polished
- Shown opposite in Black Finish
- To be inset up off the floor into a chimney
- Gas fire with Radiant Heat which heats more effectively by Radiation rather than convection which heats the air
- Realistic Coal or Pebble Fuel Effect
- Black Brick effect Fireback
- Open fronted inset gas fire
- Suitable for Class 1 Chimneys and Flues
- Natural gas only
- Inset Depth of 185mm
- Comes with 3 Year Warranty
- Click here to view the
Pureglow Gas Fires Installation and User Instructions - Click here to view the
Pureglow Sales Brochure 
Free Delivery!
estimated delivery
7 working days
was £699.00
NOW £530.00
Options | Pure Glow Carmen Hole in the Wall Gas Fire
Pureglow Full Depth Model
Trims | Pure Glow Carmen Hole in the Wall Gas Fire
Hearth & Back | Pure Glow Carmen Hole in the Wall Gas Fire
Pureglow Black Brick Back
Fuel Effect | Pure Glow Carmen Hole in the Wall Gas Fire
Pureglow Full Depth Pebble fuel effect
Energy Type | Pure Glow Carmen Hole in the Wall Gas Fire
Controls | Pure Glow Carmen Hole in the Wall Gas Fire
Manual Control
*Image for illustration purposes only
Please ensure to have a survey carried out by a Gas Safe Register registered gas installer to check and certify the compatibility of your chimney or flue with this fire before making any purchase to avoid disappointment. If you intend to install the Slimline fire into a Class 2 flue then subject to the depth you have, you may require a 3" 75mm deep rebated fire surround. * The spigot outlet of the fire is 560mm high but should still fit into the gather at the top of the fireplace as the appliance is fitted. Any modifications to the fireplace must be to a height if 560mm min.
Output depends on flue-pull, diameter of flue and conditions of fireplace. Where there is insufficient depth a deep rebate surround may be required. This gas fire incorporates an oxygen depletion device in its flame supervision which cuts off the gas to the burner if oxygen levels in the room become too low. Also due to the sheer number of varying flue boxes it is not possible to know which fires are suitable until such time as the existing fire has been removed.
Note that whilst soot deposits on a gas fire are quite normal and to be expected, they will be more visible on a pebble fuel effect and or a light coloured fireback. Although we (and our Manufacturers) display some products in photographs with and without a hearth the ultimate decision of whether a hearth is required or not is that of your registered gas installer, as Building regulations and Gas Safe Register regulations may differ in areas throughout the UK.
However for the avoidance of doubt Pureglow would recommend that a hearth is installed. With all Pureglow cast iron products you should expect slight imperfections/small marks due to the authentic manufacturing process as all products are hand finished and therefore each and every casting will be slightly different and unique in its own way which is normal and to be expected with cast products of this type. All information contained in the website is to assist in your choice of a suitable fire. This is not intended to be all the information required to install your fire. This can be obtained from Pureglow themselves. For more information visit www.pureglowltd.co.uk/.
or Firefox 
?